Bosch DCN Next Generation Operation Manual page 221

Conference System
7.15 DCN-IDESK Interpreter Desks
Before the start of a discussion or a conference, the interpreter and system parameters of the
interpreter desk can be put manually in the installation mode of the desk.
Overview
The installation mode of the desk consists of a number of menus in which options have to be
chosen. Some menus are applicable only to the desk that is being configured, whereas other
menus apply to all interpreter desks in the system.
Menu
a
b
c
d
e
f
g
h
j
k
l
m
n
o
p
Table 7.39: Installation mode menus
Notice!
In PC based systems only menus a, b, c, o and p have to be configured manually on each
desk. All other menus can be configured from the PC if software package DCN-SWSI is used.
Notice!
PC based systems using the Simultaneous Interpretation software module have extended
control and preset facilities as compared to a stand-alone interpretation system.
Notice!
A description of the Simultaneous Interpretation software manual is beyond the scope of this
manual. Refer for detailed information about this software to its own manual.
Start the installation mode
1.
Bosch Security Systems B.V.
Description
User language
Interpreter booth number
Desk number
Number of channels
Language list
Language channels
Outgoing channel A
Outgoing channel B
Number of auto-relay booths
Auto-relay booths
Microphone locks
Speak slowly signaling
Help signaling
Speech timer
Microphone source
Make sure the interpreter desk has an address (refer to Initialization, page 178).
Operation Manual
Configuration | en
Scope
System
Desk
Desk
System
System
System
Desk
Desk
System
System
System
System
System
Desk
Desk
2013.11 | V2.0 | DCN-NG_OM_V4.x
221