Bosch DCN Next Generation Operation Manual page 244

244 en | Operation
8.6 DCN-WAP Wireless Access Point
The LEDs on the wireless access point give information about the condition of the wireless
network and the wireless access point.
Notice!
You can change the condition of the system with the configuration menu of the central
control unit (refer to Configuration, page 177).
A B C
Figure 8.1: Status LEDs
Blue (A)
Flashing
(fast)
Flashing
(fast)
Flashing
(fast)
Flashing
(slow)
Flashing
(slow)
Off
2013.11 | V2.0 | DCN-NG_OM_V4.x
C B A
Red (B) Blue (C) Description
Off Off The wireless mode is set to On, and no Wireless
Discussion Units are connected to the system. Check if
another WiFi network is present and if the yellow out-of-
range LED on the back of the Wireless Discussion Units is
on.
Off Flashing No Wireless Discussion Units are connected, and menu
(fast) item 3B, one of the 3B submenus, or 4Kd of the
configuration menu of the Central Control Unit is open.
Use these menu items to configure the Wireless Access
Point.
Off On The wireless mode is set to Subscription, and no Wireless
Discussion Units are connected to the system.
Off Flashing The wireless mode is set to Sleep, and menu item 3B, one
(fast) of the 3B submenus, or 4Kd of the configuration menu of
the Central Control Unit is open. Use these menu items to
configure the wireless access point.
Off Off The wireless mode is set to Sleep.
Flashing Off The Wireless Access Point (DCN-WAP) does not contain
(fast) valid firmware and needs to downloaded using the Bosch
Download and License Tool (DCN-DLT).
Operation Manual
Conference System
Bosch Security Systems B.V.