Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual page 92

MB-T48-01
Automatic Electric Brake Removal and Installation
( Continued )
8. Slide the automatic electric brake off the drive input shaft.
9. Repair or replace components as necessary.
10. Install the new motor or reassemble in reverse order.
NOTE: Apply a small amount of grease to the input shafts.
11. Reconnect the motor and brake wires.
12. Reconnect the main positive and negative cables at the batteries.
13. Test the brake.
13. Remove the blocks from behind the wheels.
14. Release the park brake and test drive the vehicle.
Motor and Automatic Electric Brake
SECTION 3 PAGE 56