Battery Status Indicator; Reverse And Motion Alarm; Electrolyte Alarm (Optional); Windshield Washer Fluid Tank - Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual

Hide thumbs Also See for B0-T48-48 Taylor Truck T48:
Table of Contents

Advertisement

Battery Status Indicator

service to avoid damaging the batteries.
The battery status indicator is located to the left of
the hour meter. The battery status indicator has a
LED bar graph that indicates the relative state of
charge of the battery. The top LED will light only when
connected to a fully charged battery or after
completing a charging cycle. Successive lower LED's
will light as the battery charge diminishes. When
the second from the bottom LED flashes the battery
energy status is in energy reserve and should be
placed on charge as soon as possible. When the two
bottom LED's are alternately flashing the batteries
are empty and the truck should be taken out of

Reverse and Motion Alarm

The reverse alarm is located in the electron-
ics compartment mounted on the contoller
panel. The reverse alarm is activated when the
Key switch is in the "ON" position and the For-
ward-Reverse switch is depressed in the re-
verse position. The alarm makes a repeated
audible sound.

Electrolyte Alarm (Optional)

The Electrolyte Alarm is located in the battery
th
area, in the 4
battery cell from the main
battery positve cable. The Electrolyte alarm is
activated when the battery cell fluid level falls
below the level of the probe. The alarm is an
audible continuous sound along with a bi-color
indicator lamp. Inspect the batteries when the
alarm sounds or the bi-color lamp turns from
its green color to red. The vehicle batteries
should then be filled and/or charged. With the
fluid level at a normal operating level and/or
the batteries charged the alarm and light will
reset.
Windshield Washer FluidTank (ET 3000)
The windshield washer fluid tank is located
under the passenger seat. The fluid level
should be maintained with windshield
washing fluid above the lowest mark on the
tank. Allowing the tank to be used when
empty, may result in washer pump failure.
SECTION 2
PAGE 9
MB-T48-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Et-030-48 et 3000Taylor truckEt 3000Et-030-48T48

Table of Contents