Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual page 47

10. Remove the brake body.
11. Carefully remove the rubber boots, two pistons, and o-rings.
NOTE: The pistons are very brittle and break easily.
12. Clean and dry the brake body completely.
NOTE: Inspect the interior of the brake body. (If any damage
or wear is found, it must be replaced)
Make sure there are no contaminants left in the brake body.
Leaks and other damage will cause brake failure and may
result in property damage and or serious bodily injury.
13. Reassemble the brake body using clean DOT 3 brake fluid as a
lubricant. Make sure the o-rings are seated properly during
assembly.
Always use new locknuts .
If the locknuts or bolts
holding the brake to the
drive come loose, it may
result in serious bodily
injury.
Avoid ingesting brake fluid and/or contact with skin or
eyes. Always wear protective clothing and a face shield
when working with or around brake fluid.
SKIN CONTACT
Flush area immediately with water for several minutes.
EYE CONTACT
Immediately flush the eye with water for 15 minutes
and call physician.
INGESTION
Get medical attention immediately.
14. Using the appropriate procedure, reinstall the brake body onto the
vehicle including brake lines and cables and bleed the brakes.
15. Lower the vehicle.
16. Reconnect the main positive and negative cables at the batteries.
17. Remove the blocks from behind the wheels.
18. Test drive the vehicle.
SECTION 3 PAGE 11
MB-T48-01