Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual page 114

Electrical Troubleshooting
TEST 3.5
Disconnect the batteries and remove wires from the B-,
F1, and F2 terminals on the controller.
Using the diode test function on your meter, connect the
positive lead to the B- terminal on the controller.
Connect the negative lead to the F1 terminal on the
controller.
The test should show the presence of a diode
(approx 0.5v).
If the test is good, then skip ahead to test #3.6.
If the test is open or shorted then one or both
directional FET's are shorted and the controller
must be replaced.
TEST 3.6
Disconnect the batteries and remove wires from the B-, F1, and F2 terminals on the controller.
Using the diode test function on your meter, connect the positive lead to the B- terminal on the
controller.
Connect the negative lead to the F2 terminal on the controller.
The test should show the presence of a diode (approx 0.5v). If the test is open or shorted
then one or both directional FET's are shorted and the controller must be replaced.
Stop, do not continue. Reaching this point indicates an unanticipated failure or an error
was made during testing. Confirm all previous tests were performed correctly and contact
your Taylor-Dunn
®
This troubleshooting guide is written in sequential order. All tests
must be performed in the order that they are written. Starting in the
middle or skipping sections when not instructed to do so may lead to
invalid test results.
STOP
represetative for assistatnce.
After any repairs are made, completely retest the vehicle before
lowering the drive wheels to the ground. Failure to retest the vehicle
could result in unexpected movement of the vehicle resulting in injury
or property damage.
Section 4 Page 12