Charging; Battery Storage - Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual

Charging

1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
movement.
Explosive mixtures of Hydrogen gas are present within
battery cells at all times. Do not work with or charge
battery in an area where open flames (including gas
furnace or water heater pilots), sparks, cigarettes, or
any other sources of combustion are present. Always
provide ample ventilation in rooms where batteries are
being charged. Failure to do so may result in severe
property damage and or serious bodily injury.
6. Check the electrolyte level. If low, fill with distilled water up to the
correct level. Use 77-201-00 battery filler.
7. If equipped, with a Electrolyte alarm take the unit out of the battery
cell, wipe the electrode clean, and put the unit back in the battery.
8. Plug the charger into the appropriate voltage outlet.
9. Allow the charger to cycle completely before unplugging.
10. Remove the blocks from behind the wheels.
11. Release the park brake and test drive the vehicle.

Battery Storage

The following pointers will help extend the life of the battery when storing the
vehicle for the winter season:
Clean and check the electrolyte level and charge level of the battery.
•
• Do not store a battery low in electrolyte or in a low state of charge.
If possible, store the vehicle in a cool dry place, or cover the vehicle.
•
If the batteries are removed from the vehicle, do not place them directly on
the ground, concrete or solid metal surface. It is recommended to store them
on a wooden pallet or equivalent.
SECTION 3
MB-T48-01
PAGE 65