MB-T48-01
Repairing the Brake Body
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
movement.
5. Disconnect the main positive and negative cables at the
batteries.
6. Raise the rear of the vehicle and support with jack stands.
Always use a lifting strap, hoist, and jack stands, of
adequate capacity to lift and support the vehicle. Failure
to use lifting and support devices of rated load capacity
may result in serious bodily injury.
Do not let the brake body hang by the brake hose.
Support the brake body to prevent damage to the hose.
7. Disconnect the brake lines attached to the brake body.
8. Remove the two 1/4" brake body bolts.
9. Remove all of the brake accessories (brake pads, bushings, etc.).
SECTION 3
PAGE 10