Brake Pad Replacement - Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual

BRAKE PAD REPLACEMENT

1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
movement.
5. Disconnect the main positive and negative cables at the
batteries.
Always use a lifting strap, hoist, and jack stands, of
adequate capacity to lift and support the vehicle. Failure
to use lifting and support devices of rated load capacity
may result in serious bodily injury.
6. Raise the rear of the vehicle and support
with jack stands.
7. Remove the rear wheels.
8. Remove the two 1/4" brake body bolts.
9. Replace the brake bushings.
10. Inspect the rotor for damage. Minimum thickness of the rotor is
0.200". Maximul allowable runout is 0.005".
11. Replace the brake pads and reassemble the brake to the retainer
bracket.
12. Lower the vehicle.
13. Reconnect the main positive and negative cables at the batteries.
14. Remove the blocks from the wheels.
15. Test drive the vehicle.
SECTION 3
Always use new locknuts . If the
locknuts or bolts holding the
brake to the drive come loose,
it may result in serious bodily
injury.
PAGE 9
MB-T48-01