Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual page 62

MB-T48-01
9. Remove the hub from the axle yoke.
10. Clean all grease from the inside of the hub and bearings.
11. Inspect and replace the races and bearings as a set.
12. Assemble in reverse order, using new grease seals.
a. Pack inner and outer bearings with grease.
b. Tighten the spindle nut, while rotating the hub to seat the
bearings to 30 ft-lbs.
c. Back off spindle nut one flat until the hub turns, but is not
loose.
d. Install new cotter pin.
13. Install the dust cap.
14. Reinstall the brake bodies (optional) and the tire/wheel assembly.
15. Lower the vehicle.
16. Reconnect the main positive and negative cables at the batteries.
17. Remove the blocks from behind the wheels.
18. Release the park brake and test drive the vehicle.
NOTE: For a front disc brake option remove the brake body
before removing the hub.
NOTE: Catch the outer bearing as it falls out.
NOTE: It is recommended to replace both the left and right
wheel bearings at the same time.
SECTION 3 PAGE 26