Special Tools - Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual

Special Tools

Special Tools
DESCRIPTION
Pinion Seal Installation Tool
Chain Case Centering Tool
Test Light
Accelerator Test Harness
PMC Test Kit
Curtis® PMC Handheld
Programmer
GE® EV1 Analyzer
PMT/C Meter Reset Module
Sevcon® Handset Analyzer
(read only)
Sevcon® Handset Analyzer
with Speed Adjust Capability
Disc Brake Boot Installation
Tool
Pin Removing Tool
Pin Removing Tool
Hydrometer
Battery Filler
Retaining Plate Depressor
Fork Collar Weld Jig
Secondary Sheave Holder
Solder Kit For Field Stud
Pinion Gear Holding Tool
PURPOSE
Used to install the pinion seal on all chain drive trucks with
the band style brake or the speed sensor on the chain case
cover.
Used to center the chain case on the pinion shaft on all chain
drive trucks with the band style brake or the speed sensor
on the chain case cover. Includes instructions.
Used for testing electrical circuits. Powered by the truck
batteries, switchable for 12, 24, 36, and 48 volts.
Used to test the solid state accellerator module part number
series 62-033-XX.
Includes 62-027-00, 62-027-31, and supplementary
troubleshooting manual M3-001-06. For controllers
equipped with pins labeled KSI and #2 only.
Used to test and program the 62-215-00 PMC speed control
used on early model C4-25 Huskey.
Used to test the GE® EV1 speed control.
U s e d to reset the PMT/C maintenance meter after a
maintenance is completed.
Used to test the Sevcon® control systems and reset the
Smart View display (includes instructions).
Same as 62-027-61 (above) plus allows a limited range of
speed adjustment.
Used to install the rubber boot on all disc brake bodies.
Used to remove pins and sockets from AMP connectors.
Used to remove pins and sockets from MOLEX connectors.
Used to check the specific gravity of battery electrolyte.
Used to safely add water to batteries.
Used to hold down the retaining plate when disassembling
the steering gear on trucks equipped with the tilt steering.
Used when replacing the fork collar on models MX-600 and
SS5-36.
Used to hold the secondary sheave (pulley) from turning on
models R6-80 and B6-10 with the Yamaha drive.
Used to solder the aluminum field wire to the field stud. For
use on motors with soldered connections only.
Used to align the Pinion Gear and Case during assembly and
disassembly.
APPENDIX A
PART NUMBER
PAGE 2
43-201-50
41-532-50
62-027-00
62-027-31
62-027-60
62-027-10
62-027-20
96-500-43
62-027-61
62-027-62
41-350-13
75-440-55
75-442-55
77-200-00
77-201-00
96-500-39
96-500-40
96-500-14
70-210-63
96-500-42