Pinion Gear Shimming - Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual

MB-T48-01
Pinion Gear Shimming Instructions
Pinion Gear Depth and Selecting the Pinion Shim
C - B - A + (D
D = The number on the face of the pinion gear.
V
F a c e o f t h e
pinion gear
NOTE: This is required only when replacing the front or rear pinion
bearings and races or the ring and pinion gears.
NOTE: All parts must be clean and the bearings lightly lubricated.
) = Pinion Shim (mm)
V
A = The distance in millimeters from the face of the pinion
gear to the top of the inner pinion bearing race.
B = 54.
C = The number on the edge of the differential side plate
closest to the input shaft.
D = The number on the edge of the differential side plate
farthest from the input shaft.
E = The distance in millimeters from the rear of the drive
housing to the face of the pinion gear.
A
SECTION 3 PAGE 48