Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual page 69

9. Place the upper worm bearing on the worm
shaft and install the worm shaft/ball nut
assembly into the housing being careful not to
damage the worm shaft seal.
10. Install the assembled worm bearing adjuster
into the housing and tighten just enough to
remove all play in the worm shaft.
11. Install, but do not tighten the worm bearing
adjuster lock nut.
12. Rotate the worm shaft to center the ball nut in
the housing.
13. Place a new gasket onto the housing and install
the assembled pitman shaft/side cover onto the
housing using two of the three mounting bolts.
14. Pack the steering gear with grease through the
open side cover bolt hole and then install the
bolt.
15. Adjust the steering gear.
NOTE: Refer to Adjust the Steering gear
section for information regard-
ing adjusting the steering gear.
16. Once the adjustments are completed, make sure that the locking ring and jam
nut are tight.
SECTION 3
MB-T48-01
PAGE 33