Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual page 81

Assembling the 3rd Member
1. Temporarily install the pinion gear (hand tighten
only).
2. Install the carrier
bearing race ring
nuts into the
housing and cover.
3. Install the
carrier bearing
races into the
housing and
cover.
4. Place the differential assembly into the
housing.
5. Tighten the housing carrier bearing race
ring nut so that the ring gear is not in
contact with the pinion gear.
6. Remove the differential assembly.
NOTE: Do not allow the ring
nut to rotate.
SECTION 3
Be sure to pre-lube all of the bearings. Failure to do so
will cause early wear, damage and void any and all
warranties.
If the pinion gear, bear-
ings, races or the ring
and pinion were re-
placed, the pinion gear
must be re-shimmed.
(Refer to the re-shim-
ming instructions).
PAGE 45
MB-T48-01