Smart View Display - Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual

MB-T48-01

Smart View Display

The Smart View Display (SVD) functions as a Battery Status Indicator (BSI), Hour Meter (HM),
speed controller status monitor, and as an optional maintenance monitor feature. The operation of
each of these functions is listed below.
BSI: A bar graph representing the current state of charge is located across the top of the display.
When the batteries are fully charged, all segments of the bar graph will be on. As the batteries are
used, segments will turn off in the order of right to left.
When the batteries are discharged to 75%, the last three segments will flash indicating that you are
approaching the end of the battery cycle. At this time, the vehicle's batteries should be charged as
soon as possible.
At 90%, all segments will flash and the vehicles speed will be reduced. At this time, the vehicle
should be removed from service for charging. Discharging beyond 90% will result in damage to
the batteries that will shorten the battery life-span.
HM: There are two hour meter functions, Key Hours and Run Time Hours.
Key Hours is the accumulated length of time in hours that the key switch is in the "ON" position.
Run Time Hours is the accumulated length of time that the vehicles has been in operation. Time is
accumulated when the FS-1 switch in the accelerator module is closed.
One of the Hours functions is being displayed whenever the either of the Hours Indicators are
visible at the right side of the display.
Key Hours icon
Key Hours: When the display is turned on,
the Key Hours will be displayed for approxi-
mately 5-seconds as indicated by the Key
Hours Indicator located at the lower left of
the display. The icon represents the silhou-
ette of a key.
SECTION 2 PAGE 10