MB-T48-01
Bleeding the Brakes
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
movement.
5. Disconnect the main positive and negative cables at the
batteries.
Note: Start this procedure at the wheel/brake body furthest from the master
cylinder, then work toward the wheel/brake body closest to the master
cylinder.
6. Add DOT 3 brake fluid to the master cylinder. Fill the fluid to 1/4"
from the top of the chamber.
Make provisions to properly dispose of the brake fluid in the
hydraulic brake system.
7. Apply pressure to the brake pedal.
8. Attach a clear hose to the bleeder valve.
NOTE: Pump it once or twice to build up fluid pressure
NOTE: The hose should be long enough to reach the bottom
of the drip pan.
SECTION 3
PAGE 12