Taylor-Dunn B0-T48-48 Taylor Truck T48 Operation Manual page 83

15. Install the cover and all of the cover bolts.
Torque the bolts to 45-50 foot
pounds. Failure to do so will result
in early wear and tear on
components and void any and all
warranties.
16. Check the gear lash between the ring
and pinion gears. The gear lash should
be .005 to .007 inches.
17. Adjust the gear lash if needed by
tightening or loosening the carrier
bearing race ring nuts.
NOTE: To move the ring gear closer to the
pinion:
Loosen the housing carrier bearing race
ring nuts and tighten the cover carrier bear-
ing race ring nut equally.
NOTE: To move the ring gear away from
the pinion:
Loosen the cover carrier bearing race ring
nut and tighten the housing carrier race
ring nut equally.
18. Install the locking roll pins into the
housing and cover to lock the ring nuts in place.
19. Remove the pinion gear holding tool.
20. Using the appropriate procedures, install the primary reduction gear case, axles and
housings, motor, and install the complete drive onto the vehicle.
21. Fill the drive with 2 quarts of specified oil.
21. Lower the vehicle.
22. Reconnect the main positive and negative cables at the batteries.
23. Remove the blocks from behind the wheels.
24. Test drive the vehicle.
Both ring nuts must be turned the same
amount in opposite directions relative to
the previously marked starting position.
Failure to do so will result in early wear
and tear on components and void any and
all warranties.
SECTION 3 PAGE 47
MB-T48-01