Change The Stacking Method Per Job - Canon Oce VarioPrint 6000+ Series Operation Manual

Change the stacking method per job

Change the stacking method per job
Introduction
The [Offset stacking] function creates a visible distinction between sets or jobs in an output
location. The active workflow profile or the active automated workflow determines the default
type of offset stacking.
You can only change the type of [Offset stacking] per job when the [Offset stacking] setting of the
active [Workflow profile] is set to [Sets (as in job)].
NOTE
You cannot change this setting for the active print job .
NOTE
Automated workflows can be defined through the Settings Editor. You can find more
information in the online help of the Settings Editor.
Procedure
NOTE
Remember that you can only change the stacking method per job when the active [Workflow
profile] is set to [Sets (as in job)].
1.
Touch [Jobs] -> [Queues] -> [Scheduled jobs] or [Waiting jobs].
2.
Touch the job you want to change.
3.
Touch [Properties] - or touch the job 2x to open the [Properties] window.
4.
Touch the [Print delivery] button.
5.
Touch the [Offset stacking] button to toggle between [On] and [Off].
The offset stacking is defined per N sets. By default, this number is 1. If a number is specified, this
specified number of printed sets of a job will be delivered to an output location in one straight
stack, the next number of printed sets are stacked with an offset.
6.
Press [OK].
Related information
Work with the workflow profiles on page 38
126 Chapter 7 - Carry out print jobs