Change The Finishing Method - Canon imageRUNNER ADVANCE C9075S PRO Operating Information Manual
Color digital multifunction imaging system
Hide thumbs
Also See for imageRUNNER ADVANCE C9075S PRO:
- Customer expectation document (56 pages) ,
- Safety instructions (48 pages) ,
- User manual (20 pages)
Table of Contents
Advertisement
Change the finishing method
Change the finishing method
Introduction
The required finishing method is usually set in the printer driver. However, you can
change the finishing method on the operator panel.
Depending on the configuration of your system you can change the following finishing
methods, for example.
•
Number of staples.
•
Number of punch holes.
•
The location of the staples or punch holes.
How to change the finishing method
Touch 'Jobs' -> 'Waiting jobs'.
1.
Touch the job you want to change.
2.
#
NOTE
You can only change the settings of the active print job
printer (press the 'Stop' button two times).
Touch 'Properties', or touch the job two times to open the 'Properties' window.
3.
Touch the 'Binding' button.
4.
Make the required changes.
5.
Press 'OK'.
6.
Press 'OK'.
7.
168
Chapter 6 - Print jobs
after you stopped the
Advertisement
Table of Contents
