Auto Bystarter Inspection/Removal - KYMCO GRAND DINK 250 Manual

13
. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK
AUTO BYSTARTER INSPECTION
/REMOVAL
AUTO BYSTARTER INSPECTION
Measure the resistance between the auto
bystarter wire terminals.
Resistance: 10Ω (10 minutes minimum after
stopping the engine)
If the reading is not within the limit, replace
the auto bystarter with a new one.
Connect a hose to the fuel enriching circuit
of the carburetor.
bystarter green/black wire to the positive (+)
terminal of a battery and black/white wire to
the negative (-) terminal.
and blow the hose with mouth.
passage is blocked, the auto bystarter is
normal.
Disconnect the auto bystarter from the
battery. Wait 30 minutes and blow the
hose with mouth..
the hose, the auto bystarter is normal.
AUTO BYSTARTER REMOVAL
Remove the one set plate screw and set plate
and then remove the auto bystarter from the
carburetor body.
13-11
Connect the auto
Wait 5 minutes
If the
If air can be blown into
B/W
G/B
Hose
Auto Bystarter
Set Plate
GRAND DINK 250
Screws