Download Print this page

Advertisement

12
. COOLING SYSTEM
Install the water pump shaft and shaft inner
bearing into the waster pump assembly.
Install the snap ring to secure the inner
bearing properly.
Install the dowel pins and a new gasket and
then install the water pump assembly to the
right crankcase cover.
Tighten the eight bolts to secure the right
crankcase cover.
When installing the water pump
assembly, aligning the groove on the
water pump shaft with the tab on the oil
pump shaft.
WATER PUMP/IMPELLER
INSTALLATION
When the mechanical seal is replaced, a
new seal washer must be installed to the
impeller.
12-13
Snap Ring
Inner Bearing
Bolts
Water Pump Assembly
Mechanical Seal
Impeller
Seal Washer (Porcelain)
GRAND DINK 250
Water Pump Shaft

Advertisement

Troubleshooting

   Also See for KYMCO GRAND DINK 250

Comments to this Manuals

Symbols: 0
Latest comments: