Auto Bystarter Inspection/Removal - KYMCO People Service Manual

13. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK
AUTO BYSTARTER INSPECTION /REMOVAL
AUTO BYSTARTER INSPECTION
Measure the resistance between the auto
bystarter wire terminals.
Resistance: 14-20: (10 minutes
minimum after stopping the engine)
If the reading is not within the limit, replace
the auto bystarter with a new one.
Connect a hose to the fuel enriching circuit of
the carburetor. Connect the auto bystarter
green/black wire to the positive (+) terminal of
a battery and black/white wire to the negative
(-) terminal. Wait 5 minutes and blow the
hose with mouth. If the passage is blocked,
the auto bystarter is normal.
Disconnect the auto bystarter from the battery.
Wait 30 minutes and blow the hose with
mouth.. If air can be blown into the hose,
the auto bystarter is normal.
AUTO BYSTARTER REMOVAL
Remove the one set plate screw and set plate
and then remove the auto bystarter from the
carburetor body.
13-11
PEOPLE/PEOPLE S 250
B/W
G/B
Hose
Auto Bystarter
Set Plate
Screws