Clutch/Driven Pulley - KYMCO GRAND DINK 250 Manual

Hide thumbs Also See for GRAND DINK 250:
Table of Contents

Advertisement

8
. DRIVE AND DRIVEN PULLEYS/
KICK STARTER
Install the drive pulley face, washer and drive
face nut.
Hold the drive pulley with the universal
holder and tighten the drive face nut.
Torque: 88.2 98N-m
Special
Universal Holder
• Do not get oil or grease on the drive
belt or drive pulley faces.

CLUTCH/DRIVEN PULLEY

Remove the left crankcase cover. ( 8-3)
Remove the drive pulley and drive belt.
( 8-4)
Hold the clutch outer with the universal
holder and remove the clutch outer nut.
Special
Universal Holder
Remove the clutch outer.
INSPECTION
Inspect the clutch outer for wear or damage.
Measure the clutch outer I.D.
Service Limit: 153.5mm replace if over
Drive Pulley Face
Drive Face Nut
Washer
Universal Holder
Drive Pulley
Clutch Outer
Universal Holder
GRAND DINK 250
8-8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents