Download Print this page

Advertisement

1
. GENERAL INFORMATION
After clamping, check each wire to make
sure it is secure.
Do not squeeze wires against the weld or
its clamp.
After clamping, check each harness to
make sure that it is not interfering with any
moving or sliding parts.
When fixing the wire harnesses, do not
make it contact the parts which will
generate high heat.
Route wire harnesses to avoid sharp edges
or corners.
Avoid the projected ends of
bolts and screws.
Route wire harnesses passing through the
side of bolts and screws.
projected ends of bolts and screws.
1-5
No Contact
Avoid the
GRAND DINK 250
Route harnesses so they are neither
pulled tight nor have excessive slack.
Protect wires and harnesses with electrical
tape or tube if they contact a sharp edge or
corner.
When rubber protecting cover is used to
protect the wire harnesses, it shall be
installed securely.
Do not break the sheath of wire.
If a wire or harness is with a broken sheath,
repair by wrapping it with protective tape
or replace it.
When installing other parts, do not press or
squeeze the wires.
Do not press or
squeeze the
i
Do not pull
too tight

Advertisement

Troubleshooting

   Also See for KYMCO GRAND DINK 250

Comments to this Manuals

Symbols: 0
Latest comments: