Download Print this page

Advertisement

14. STEERING HANDLEBAR/FRONT WHEEL/FRONT
BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
Check the piston for scratches or wear.
Measure the piston O.D. with a micrometer
gauge.
Top Service Limit: 26.91mm
Under Service Limit: 33.87mm
Check the caliper cylinder for scratches or
wear and measure the cylinder bore.
Top Service Limit: 27.05mm
Under Service Limit: 34.01mm
ASSEMBLY
Clean all removed parts.
Apply silicon grease to the piston and oil seal.
Lubricate the brake caliper cylinder inside
wall with brake fluid.
Install the brake caliper piston with grooved
side facing out.
Install the piston with its outer end
protruding 3 5mm beyond the brake
caliper.
Wipe off excessive brake fluid with a clean
shop towel.
Apply silicon grease to the
brake caliper seat pin and caliper inside.
Install the brake caliper seat.
INSTALLATION
Install the brake caliper to the shock absorber
and tighten the two bolts.
Torque: 24.5 34.3N-m
When installing the brake caliper, be
sure to position the brake disk between
the two brake pads.
GRAND DINK 250
Brake Caliper
14-12

Advertisement

Troubleshooting

   Also See for KYMCO GRAND DINK 250

Comments to this Manuals

Symbols: 0
Latest comments: