Setting Up Snmp - Polycom QDX 6000 Administrator's Manual

Managing the System Remotely

Setting Up SNMP

The Polycom QDX 6000 system sends Simple Network Management Protocol
(SNMP) reports to indicate various conditions.
To configure the Polycom QDX 6000 system for SNMP management:
1
2
Setting
Enable SNMP
Read-Only
Community
Contact Name
Location Name
System
Description
9-4
Access the SNMP configuration screen either in the Polycom QDX 6000
web interface or on the Polycom QDX 6000 system. In the Polycom QDX
6000 Web interface, go to Admin Settings > Global Services > SNMP.
On the Polycom QDX 6000 system, go to System > Admin Settings >
Global Service > SNMP.
Configure these settings on the SNMP screen:
Description
Allows administrators to manage the system remotely using
SNMP.
Specifies the SNMP management community in which you
want to enable this system. The default community is Public.
Note: Polycom does not support SNMP write operations for
configuration and provisioning; the read-only community string
is used for both read operations and outgoing SNMP traps.
Specifies the name of the person responsible for remote
management of this system.
Specifies the location of the system.
Specifies the type of video conferencing device.