Polycom QDX 6000 Administrator's Manual page 26

Monitors and Cameras
3
Setting
Camera Control
Protocol
Camera Pan/Tilt
Speed:
EagleEye Camera
Aspect Ratio
Configuring Advanced Polycom EagleEye Camera Settings
You can use the system's web interface to configure or restore the following
Polycom EagleEye camera settings:




To adjust Polycom EagleEye camera's brightness, black level, or color
saturation:
1
2
3
4
5
6
7
To restore the Polycom EagleEye camera's default settings:
1
2
3
3-8
Select and configure these settings:
Description
Specifies the communication protocol for the camera.

Auto - The camera automatically selects the
communication protocol.

PELCO-P-— The camera uses the PELCO-P protocol
for communication.

PELCO-D - The camera uses the PELCO-D protocol for
communication.
Sets the camera pan rate.

Slow - The camera pans at a low rate.

Medium - The camera pans at a medium rate.

Fast - The camera pans at a high rate.
Specifies the aspect ratio used by the Polycom
EagleEye™ camera.
Brightness
Black Level
Color Saturation
White Balance
Make sure that the system and camera are powered on and awake.
On a computer, open a web browser.
In the browser address line, enter the system's IP address, for example,
http://10.11.12.13, to go to the Polycom QDX 6000 web interface.
Go to Admin Settings > Cameras.
Click Advanced.
Select values for brightness, black level, and color saturation.
Click Update.
Make sure that the system and camera are powered on and awake.
On a computer, open a web browser.
In the browser address line, enter the system's IP address, for example,
http://10.11.12.13, to go to the Polycom QDX 6000 web interface.