Proxim Orinoco AP-2500 User Manual page 68

Network Parameters
DHCP Pool parameters are dependent on which DHCP Server Configuration you use. See
Configuration Options for information. The following parameters are configurable:
• Server IP Address: Specifies the IP address to which DHCP clients send DHCP requests. The server responds to
the client request with an offer message containing the DHCP lease address. The server address can be any IP
address that is not in the DHCP pool range, but it must be in the same IP subnet as the pool.
• Start IP Address: Specifies the first IP address in the address range that the AP will use to provide addresses to
subscribers.
• End IP Address: Specifies the last IP address in the address range that the AP will use to provide addresses to
subscribers.
• Subnet Mask: Specifies the subnet mask that the AP will assign to subscribers.
• Lease Time: Specifies in minutes the length of time for which the subscriber's IP address lease is valid. A
subscriber must renew its address lease after the lease time elapses. The default is 1440 minutes. This parameter
supports a range from 0 (lease never expires) to 65536 minutes.
• DHCP Pool: Specifies the type of IP address the AP will provide to clients: Private or Public. A public IP address
will not be translated by DAT.
• IP Upsell Pool: Designates this pool as an IP Upsell Pool.
• Default Pool: Designates this pool as the Default Pool.
• Create: Creates the DHCP Pool.
NOTE: Do not allow pools to overlay.
68
DHCP Server