Proxim Orinoco AP-2500 User Manual page 135

Public Space Parameters
Figure 5-18 Add RADIUS Service Profile
4. Configure the following settings:
• Enter a Unique Name for the RADIUS service profile.
• Authentication:
a. Select the Enable radio button for Enable Authentication Service.
b. Enter the server's IP address in the Primary Auth Server field or enter the DNS name in the Primary
Auth DNS Server field. Use either identifier but not both.
c. Enter the Primary Auth Port number.
— This port must match the RADIUS Authentication port supported by your RADIUS program. Most
RADIUS servers use port 1812 (the default setting) for Authentication. However, Funk Steel-belted
RADIUS uses port 1645.
d. Enter the Shared Secret for the AP and RADIUS server in Primary Auth Secret Key field. This is the
same Shared Secret that you used when you added the AP as one of the RADIUS server's clients.
e. Repeat the above procedure for the Secondary Server parameters if you have a back-up RADIUS
server.
• Accounting:
a. Select the Enable radio button for Enable Acct Service.
b. Enter the server's IP address in the Primary Acct Server field or enter the DNS name in the Primary
Acct DNS Server field. Use either identifier but not both.
c. Enter the Primary Acct Port number.
d. Enter the Shared Secret for the AP and RADIUS server in Primary Acct Secret Key field. This is the
same Shared Secret that you used when you added the AP as one of the RADIUS server's clients.
135