Configure Management Ports; Edit Ip Access Table; Configure Serial Port Interface - Proxim Orinoco AP-2500 User Manual

Using the Command Line Interface

Configure Management Ports

[Device Name]>set snmpifbitmask <0, 1, 4, 8, 15 (see below)>
[Device Name]>set httpifbitmask <0, 1, 4, 8, 15 (see below)>
[Device Name]>set telifbitmask <0, 1, 4, 8, 15 (see below)>
Choose from the following values:
Interface bitmask
0 = disable (all interfaces)
1 = ethernet if
4 = pcCardA if
8 = pcCardB if
15 = allInterfaces

Edit IP Access Table

[Device Name]>set mgmtipaccesstbl <index> ipaddr <IP address> ipmask <subnet mask>

Configure Serial Port Interface

[Device Name]>set serbaudrate <2400, 4800, 9600, 19200, 38400, 57600>
[Device Name]>set serflowctrl <none, xon/xoff>
[Device Name]>show serial
Figure A-15 Result of "show serial" CLI Command
NOTE: To avoid unexpected performance of your AP-2500, leave the setting Flow Control to its default value (none)
unless you are sure what this setting should be.
Description
All management channels disabled
Ethernet only enabled
Wireless A only enabled
Wireless B only enabled
All management channels enabled
219