Using the Command Line Interface
Ethernet Interface Parameters
Name
Ethernet Interface
Speed
MAC Address
Management Parameters
IP Access Table Parameters
When creating table entries, you may either specify the argument name followed by argument value or simply entering
the argument value. When only the argument value is specified, then enter the values in the order depicted by the
following table. CLI applies default values to the omitted arguments. Due to the nature of the information, the only
argument that can be omitted is the "comment" argument.
Name
IP Access Table
Table Index
IP Address
IP Mask
Comment (optional)
Status (optional)
Access Control Parameters
Name
Access Control
Access Control On
Block Telnet Access
Block Web Access
Access Control IP Table
Table Index
Access Control Range
Starting IP Address
Access Control Range
Starting IP Address
Type
Values
Group
N/A
Integer
10halfduplex
10fullduplex
10autoduplex
100halfduplex
100fullduplex
autohalfduplex
autoautoduplex (default)
PhyAddress
N/A
Type
Values
Table
N/A
Integer
User Defined
IpAddress
User Defined
IpAddress
User Defined
DisplayString
User Defined
Integer
enable
disable
delete
Type
Values
Group
N/A
Integer
disable (0)
enable (1)
Integer
disable (0)
enable (1)
Integer
disable (0)
enable (1)
Table
N/A
Integer
N/A
IpAddress
User Defined
IpAddress
User Defined
Access
CLI Parameter
R
ethernet
RW
etherspeed
R
ethermacaddr
Access
CLI Parameter
R
mgmtipaccesstbl
N/A
index
RW
ipaddr
RW
ipmask
RW
cmt
RW
status
Access
CLI Parameter
R
accessctl
RW
accessControlOn
RW
blockTelnetAccessOn
RW
blockWebAccessOn
RW
accessControlIpTable
R
acIndex
RW
acStartAddress
RW
acEndAddress
228