Ffb Card (Workstation Only); Removing An Ffb Card - Sun Microsystems Ultra 1 Creator Series Service Manual

10.4

FFB Card (Workstation Only)

To remove and replace the FFB card, proceed as follows.
Note – Illustrations supporting the FFB card removal and replacement are not
representative of a system unit or sever chassis.
10.4.1

Removing an FFB Card

1. Power-off the system.
See Section 6.2 "Powering Off the System" on page 6-2.
2. Disconnect the video cable from the graphics card 13W3 video connector.
3. Remove the unit cover.
See Section 7.1 "Removing the Cover" on page 7-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
4. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-2.
5. Unlock the card retainers ( ).
FIGURE 10-16
Chapter 10 System Board and Component Replacement 10-19