Wsmfp - Ricoh Printer Quick Installation Manual

5. Monitoring and Configuring the Printer
• Be sure to specify the interface.
• wlan can be specified only when the wireless LAN interface unit is installed.
ether
wlan
Address configuration
Use the following command to configure a WINS server IP address:
msh> wins "interface_name" {primary|secondary} "IP address"
• Use the "primary" command to configure a primary WINS server IPv4 address.
• Use the "secondary" command to configure a secondary WINS server IPv4 address.
5
• Do not use "255.255.255.255" as the IPv4 address.
NBT (NetBIOS over TCP/IP) Scope ID Selection
You can specify the NBT scope ID.
msh> wins "interface_name" scope "scope ID"
• The scope ID can be entered using up to 31 alphanumeric characters.
• Be sure to specify the interface.
• wlan can be specified only when the wireless LAN interface unit is installed.
ether
wlan

wsmfp

Use the "wsmfp" command to view and configure WSD (Device) and WSD (Printer) settings.
View settings
msh> wsmfp
Comment settings
msh> wsmfp comments "comment"
• If you do not specify a comment, current setting is displayed.
Location configuration
mah> wsmfp location "location"
256
Interface name
Interface name
Interface configured
Ethernet interface
Wireless LAN interface
Interface configured
Ethernet interface
Wireless LAN interface