Setting The Periodic Connection Schedule; Figure 3.7 [Periodical Connection Settings] Window; Table 3.3 Input Items For The [Periodical Connection Settings] Window - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 3 REMCS Service Start Procedure
Item
Division Size
Encryption type
2. Click the [Next] button.
After the connection configuration is registered, the window shown in
settings] window appears. Proceed to
3.2.4

Setting the periodic connection schedule

In the window shown in
schedule.
After starting the REMCS service, you can still change the periodic connection schedule by clicking [Periodical
Connection] from the menu in the window shown in

FIGURE 3.7 [Periodical Connection settings] window

1. Specify the values for the following items.

TABLE 3.3 Input items for the [Periodical Connection settings] window

Item
current schedule
of Periodic
Connection
Period
Enter the partitioning size in the range of 10 to 100 Kbytes. The initial value
is 64 Kbytes.
If the S/MIME format is not supported before the firmware update, the initial
value is [Previous encryption]. The initial value at the firmware update time is
the setting before the firmware update.
3.2.4 Setting the periodic connection
FIGURE 3.7 [Periodical Connection settings]
The initial values are [Every week] and [10:00] to [15:00]. Specify values if you need
to change the setting.
Specify the setting from [Every day], [Every day (excluding Sunday)], [Every day
(excluding Saturday & Sunday)], and [Every week].
Description
FIGURE 3.7 [Periodical Connection
window, specify the periodic connection
FIGURE 4.1 [REMCS initial]
Description
19
schedule.
window.
C122-E120-06EN