Table 6.23 Message In The [Sending Hardware Configuration Information] Window; Table 6.24 Message In The [Sending Software Configuration Information] Window - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 6 REMCS Messages
Message code
RMG_0061 Temporary disconnection to the REMCS Center
completed.
RMG_0062 Temporary disconnection frame display completed.
RMG_0063 Reconnection frame display completed.
RMG_0064
Execute reconnection to the REMCS Center. Are you
sure?
Registration has not executed, Setup is incomplete.
RMG_0092

TABLE 6.23 Message in the [Sending Hardware Configuration Information] window

Message code
RMG_0002 Failed to make frame screen data. (xxx)
RMG_0004 Invalid CGI parameter specified.
RMG_0130 Sending Hardware Configuration Information frame
display completed.
Sending hardware configuration information
RMG_0132
completed.
RMG_0133 Failed to send hardware configuration information.
(xxx)
RMG_0136
Send hardware configuration information to the
REMCS Center.
RMG_0138
Execute hardware configuration information sending.
Confirm sending result on event log display frame.
RMG_0140 Hardware configuration information sending started. None.

TABLE 6.24 Message in the [Sending Software Configuration Information] window

Message code
Failed to make frame screen data. (xxx)
RMG_0002
RMG_0004
Invalid CGI parameter specified.
Message
Message
Message
72
Action
Click the [OK] or [Cancel]
button.
Retry after registration is
complete.
Action
If the error still occurs when you
retry the operation, exit and
restart the REMCS window and
try again. If the problem is not
solved, contact the support
center.
None.
Check whether the network
status is normal.
Click the [OK] or [Cancel]
button.
Confirm sending result on event
log display frame.
Action
If the error still occurs when you
retry the operation, exit and
restart the REMCS window and
try again. If the problem is not
solved, contact the support
center.
C122-E120-06EN