PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 3 REMCS Service Start Procedure
3.4
Replacing the S/MIME certificate during the initialization work
This section describes the procedure for replacing the certificate.
1. Click [Replacement of certificates] from
[Replacement of certificates] window (during initialization
FIGURE 3.19 [Replacement of certificates] window (during initialization work)
2. Specify the certificate file and then click the [Next] button.
window (during initialization
FIGURE 3.20 [Confirmation of certificate] window (during initialization work)
3. Click the [Next] button to output the following confirmation message.
"The certificates will be replaced. Once the replacement of certificates proceeds, the report to the REMCS
center will not be done until connected confirmation is completed. Are you sure?"
FIGURE 3.4 [Initial Settings] window
work).
29
to display
work).
FIGURE 3.20 [Confirmation of certificate]
FIGURE 3.19
C122-E120-06EN