Table 6.32 Messages In The [Replacement Of Certificates] Window; Table 6.33 Messages In The [Confirmation Of Certificate] Window - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 6 REMCS Messages

TABLE 6.32 Messages in the [Replacement of certificates] window

Message code
RMG_0002 Failed to make frame screen data. (xxx)
RMG_0004 Invalid CGI parameter specified.
RMG_0033
Invalid directory name specified.
RMG_0036
Required entry.
RMG_0142
The file doesn't exist in the selected directory.
RMG_0211
The specified file can not be upload.
Failed to upload the certificates.(xxx)
RMG_0212
RMG_0213
Upload of the certificates has been completed.
RMG_0214 The frame display of the permutation of the
certificates completed.
RMG_0215
This certificate cannot be verified up to a CA
certificate.
RMG_0224 This certificate is the same as the one used now. The
certificate need not be imported.

TABLE 6.33 Messages in the [Confirmation of certificate] window

Message code
RMG_0001 Failed to get Machine status.(xxx)
Failed to make frame screen data. (xxx)
RMG_0002
RMG_0004 Invalid CGI parameter specified.
RMG_0041 Failed to setting Machine status.(xxx)
RMG_0216 The certificates will be replaced. Once the
replacement of certificates proceeds, the report to the
REMCS center will not be done until connected
confirmation is completed. Are you sure?
Message
Message
77
Action
If the error still occurs when you
retry the operation, exit and
restart the REMCS window and
try again. If the problem is not
solved, contact the support
center.
Enter a valid directory.
Enter data for the item.
Check the entered directory name
and file name, and enter them
correctly.
Enter a valid file name.
If the error still occurs when you
retry the operation, exit and
restart the REMCS window and
try again. If the problem is not
solved, contact the support
center.
None.
Confirm that the specified
certificate is valid.
Confirm the file to be imported.
Action
If the error still occurs when you
retry the operation, exit and
restart the REMCS window and
try again. If the problem is not
solved, contact the support
center.
Click the [OK] or [Cancel]
button.
C122-E120-06EN