Figure 3.4 [Initial Settings] Window - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 3 REMCS Service Start Procedure

FIGURE 3.4 [Initial Settings] window

Newly setting up the environment
The procedure for newly setting up the environment is as follows.
1. Select the connection configuration from the following.
- Internet Connection(Mail Only): The initial setting for the connection configuration
- P-P Connection(ISDN: Mail Only): Connection via ISDN
- P-P Connection(VPN: Mail Only): Connection via VPN
2. Click the [Next] button.
After the connection configuration is registered, the corresponding setting window appears.
The following procedure is for cases where the environment information already exists.
If the following setting information exists in another machine or was previously backed up and saved in your
machine, you can perform automatic registration by importing the information.
- Customer information: rm_bkcus.def
- Environment information: rm_bkenv.def
For details on the procedure when the environment information is already available, see
registration result.
When the connection type is [Internet Connection(Mail Only)]
If you selected [Internet Connection(Mail Only)] in the window shown in
the window shown in FIGURE 3.5 [Internet(Mail Only) connection environment settings] window
the information for sending e-mail via the Internet.
After setting the REMCS service, you can still change the connection configuration by clicking [Initial Settings]
from the menu in the window shown in FIGURE 4.1 [REMCS initial]
16
3.2.6 Confirming the
FIGURE 3.4 [Initial Settings]
window.
window,
appears. Specify
C122-E120-06EN