Table 6.13 Messages In The [Point-To-Point Connection Environment Settings] Window - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 6 REMCS Messages
Message code
RMG_0041 Failed to setting Machine status.(xxx)
RMG_0042 Internet(Mail Only) connection environment setting
frame display completed.
RMG_0043 Failed to set REMCS environment (Internet
connection(Mail only)). (xxx)
RMG_0044 Registration of REMCS environment data (Internet
connection(Mail only)) completed.
RMG_0056 Failed in the connection check notification. (xxx)
RMG_0095 Connection type mismatch.
RMG_0181 Invalid E-mail address specified.
RMG_0189 Execute registration of REMCS environment
data.After this operation, all events are not sent to the
REMCS Center until connection check is completed.
\nAre you sure?
RMG_0207 Invalid value in [Split size].Please specify it within the
range of 10-100.
RMG_0208 Invalid value in [Split size].Please specify it within the
range of 64-512.

TABLE 6.13 Messages in the [Point-to-Point Connection environment settings] window

Message code
RMG_0001 Failed to get Machine status. (xxx)
RMG_0002 Failed to make frame screen data. (xxx)
RMG_0004 Invalid CGI parameter specified.
RMG_0006 Failed to get connect mode. (xxx)
Message
Message
64
Action
If the error still occurs when you
retry the operation, exit and
restart the REMCS window and
try again. If the problem is not
solved, contact the support
center.
None.
Confirm the FQDN or IP address
of the specified SMTP server.
Also check whether the network
status is normal.
None.
Check whether the network
status is normal.
If the error still occurs when you
retry the operation, exit and
restart the REMCS window and
try again. If the problem is not
solved, contact the support
center.
Enter a valid value.
Click the [OK] or [Cancel]
button.
Enter a valid value.
Action
If the error still occurs when you
retry the operation, exit and
restart the REMCS window and
try again. If the problem is not
C122-E120-06EN