Setting Up Serial Console Connection - Fujitsu PRIMERGY BX900 User Manual

2.3 Setting up serial console connection

This section shows how to set up serial console connection to access connection blade CLI
Step1: Connect MMB and PC console port with a console cable. Or use a telnet / SSH session to the MMB
Step2: Configure terminal software in PC as follows.
- 8 data bits, 1 stop bit and no parity
- 115200 baud
- No flow control
Step3: Login MMB CLI. (username : admin, password : admin in default)
Step4: Enter 3 in Console Menu.
Console Redirection Table Menu appears.
+-----------------------------------------------------------------------------+
| Console Redirection Table
+-----------------------------------------------------------------------------+
(1) Console Redirect Connection Blade
(2) Set Return Hotkey , Ctrl+(a character) : Q
(3) Set Console Redirection Timeout
Enter selection or type (0) to quit:
Step5: Enter the connection blade number which you'd like to configure.
+------------------------------------------------------------------------------+
| Console Redirect Connection Blade
+------------------------------------------------------------------------------+
(1) Console Redirect Connection Blade-1
(2) Console Redirect Connection Blade-2
(3) Console Redirect Connection Blade-3
(4) Console Redirect Connection Blade-4
(5) Console Redirect Connection Blade-5
(6) Console Redirect Connection Blade-6
Enter selection or type (0) to quit: 3
PRIMERGY 10GbE Connection Blade 18/8 User Guide
: 900
page_3_1
11 / 95
page_3