Fujitsu PRIMEQUEST 1000 Series Installation Manual page 101

PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 6 REMCS Messages
Message code
(Message from the SMTP server)
xxxxxxxxxxxxxxxxxxxx
RL:xxx,ML:xxx\n
RMG_2007
(SMTP)An error was detected between the mail(POP3) server.
POP before SMTPauthentication failed.
The following causes can be considered.
- The POP3 server name is wrong.
- User name is wrong.
- Passwd is wrong.
(Message from the POP3 server)
xxxxxxxxxxxxxxxxxxxx
RL:xxx,ML:xxx
RMG_2008
(SMTP)An error was detected between the mail(POP3) server.
An error was detected during communication to the specified POP3 server.
The following causes can be considered.
- The POP3 server name is wrong.
- When the DNS server is used, the DNS server is not running.
- The problem of the network between POP3 server.
(Message from the POP3 server)
xxxxxxxxxxxxxxxxxxxx
RL:xxx,ML:xxx
RMG_2009
(SMTP)The error was detected between the mail(POP3) server.
The timeout error occurred in communication with a POP3 server.
- The problem of the network between POP3server.
- POP3 server is not running.
RL:xxx,ML:xxx
RMG_2010
(SMTP)An error was detected during communication to the specified mail(POP3) server.
The POP3 server name is wrong, or the POP3 server is not running.
The following causes can be considered.
- The POP3 server name is wrong.
- When the DNS server is used, the DNS server is not running.
- The problem of the network between POP3 server.
(Message from the POP3 server)
xxxxxxxxxxxxxxxxxxxx
RL:xxx,ML:xxx
RMG_2011 (SMTP)The error was detected during communication to the specified mail(SMTP)
server.
Authentication failed on SMTP server.
The user name or password is wrong, so it cannot authenticate on SMTP server.
(Message from the POP3 server)
xxxxxxxxxxxxxxxxxxxx
RL:xxx,ML:xxx
Message
81 C122-E120-06EN