Felix printers Felix 2.0 Instruction Manual page 7

Take beam 4 and 1. They must be connected as oriented in the
above picture.
Screw the frame connectors in the bottom of beam 4 as indicated in
the figure. Then slide beam 4 onto beam 1.
Slide beam 4 in position. On the side of beam 1 where the hex-key
is positioned there are two drilled holes. Tighten the frame
connectors by sticking the hex-key through the holes. Do not fix it
too tight because fine-tuning/leveling is needed later on.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
www.FELIXprinters.com

Slide one of the two beams number 2 onto beam 1. Watch the
orientation of the drilled hole.
Turn the frame and fix beam 2 onto beam 1. Again not too tight.
Page 7 of 51