Connect All Wires To The Electronics Board - Felix printers Felix 2.0 Instruction Manual

12.3 CONNECT ALL WIRES TO THE ELECTRONICS
BOARD.
We now will connect all the wires to the electronics board and make it
look like this
Step by step we will connect the wires to the board
All wires have to be screwed under a screw terminal. These are the
steps:
- Cut the wire to length,
- Strip the wire ends approx. 5mm, like shown above. Not too long
because that could potentially cause a short circuit with other wires.
TIP: It is recommended to use cable-ties to form nice cable loops and
get a nice wiring job. You can remove excessive ones on the
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
go.
www.FELIXprinters.com

Mount the extruder motor like indicated above.
Ext
r
Do this for the rest of the motor wires. Note the cable ties.
Take the wires of the x-axis opto-sensor, strip the ends.
Mount it as indicated above.
Repeat the same for the other axes.
Z
Y
X
X
Y
Z
Page 39 of 51