Module 5: Table (Time: 1-2 Hours) - Felix printers Felix 2.0 Instruction Manual

10

MODULE 5: TABLE (TIME: 1-2 HOURS)

Important notes:
Work carefully; this will benefit the print quality. Make sure that you don't warp the surface of the table by exerting too
much force /weight on the table
BOM table
Part description
table_2mm
Foil heater
The goal of this module is to get the foil heater onto the aluminum
plate. The picture above shows the back/bottom side of the plate.
For illustrative purposes the view above is the top-side. Where you
can see the countersunk hole.
Clean the backside of the plate with detergent.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
Amount
1
4
www.FELIXprinters.com

SLOWLY and CAREFULLY remove the protective layer from the foil
heater. The adhesive layer should remain intact as good as possible.
Place the sticker without bubbels on the surface. By wiping it piece
by piece on the surface from the middele to the edge.
Page 26 of 51