Felix printers Felix 2.0 Instruction Manual page 21

Mount the extru_base_pt4 as shown above.
Move hot-end into slot and make sure edge of hot-end touches the base
of the extruder.
Close the hinge door and screw in the m4x40 bolt. Make sure the hot-
end is not free to move, otherwise exert more force on the m4x40 bolt.
Guide the cables as shown above. Use the hole of the fan and a cable-tie
to fix the hot-end cables. Make sure it is done this way, it also gives
tension release to the hot-end cables.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
www.FELIXprinters.com

Insert the belt tensioning part as shown above.
Congratulations you've finished the extruder module!
Page 21 of 51