Felix printers Felix 2.0 Instruction Manual page 32

Push the belt into the small printed clamp, while at the same time
tensioning the belt by hand. Important is that the small clamp is
touching the right edge of the bigger part as shown in the picture
above.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
www.FELIXprinters.com

Next step is to tension the belt by turning the tensioning bolt. See
picture above. The belt should be tensioned when the distance
between the parts is approx. 1 to 2 mm.
Check if you applied enough tension by pushing the belt as displayed
above. It should feel firm.
Congratulations, you are done with the mechanics of the printer.
Page 32 of 51