Felix printers Felix 2.0 Instruction Manual page 40

Bed
Connect the thermistors(temperature sensor) of the heated bed(red
wires) and hot-end(black wires)
Connect the wires of the fans.
1. Switchable fan which blows air through the airduct of the
extruder.
2. Fan which is always on and cools the top part of the hot-
end.
IMPORTANT: match the color (polarity) of the wires.
1
Connect the heater wires of the bed and hot-end
1. Bed
2. Hot-end
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
Hot-end
1
2
2
www.FELIXprinters.com

Connect green and purple wire.
Green wire functions as an on-off switch for the printer.
The purple wire is the standby power for the logic of the electronics.
Then mount the yellow and black wires. In total there are 4 black and 4
yellow wires. Join the wires together as shown above and mount them
under the terminal blocks.
Page 40 of 51