Felix printers Felix 2.0 Instruction Manual page 17

Insert a thin nut m4 as shown above. Before doing that clean the hole
out a little and insert the nut.
Mount parts onto the extruder arm:
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
www.FELIXprinters.com

From right to left. M4x20 bolt, 2x small washer, bearing, small washer,
plastic part, thin nut.
Mount the extruder wheel onto the motor with the little set-screw from
the bag of the extruder wheel. The set-screw should not stick out more
then 0.5mm, because it might then scrape the surrounding plastic
parts..
NOTE 1: sometimes the tolerances of the extruder wheel are tight. It is
very difficult to get it on the motor-axle. DO NOT force it on there, but
try to drill out the hole with a 5mm drill, until it fits smoothly on the
motor-shaft.
Page 17 of 51