Table of Contents
Advertisement
Mount the opto-sensors with the small Philips head screws.
(Depending on the delivered batch it could be bronze or stainless steel
screws)
Distance pulley to motorface = 1-2mm
Place the pulley upside down on the motorshaft. The distance of the
bottom of the pulley to the faceplate of the motor should be 1-2mm.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
www.FELIXprinters.com
M4x20 bolt
Take the z-axis_limitswitchvane and slide the nut into the slot. On top
screw in an m4x20 bolt. Don't screw it all the way in, let the tip of the
bolt touch the flange as indicated in the picture.
Mount the z-axis-limitswitch vane with an m4x20 bolt + washer. The
bracket should be approx. 1cm from the top of the rail. This is the
adjusting mechanism for the z-axis height and will be covered later for
finetuning.
M4 thin nut
Page 14 of 51
Hide quick links:
Advertisement
Table of Contents
