Firmware update To update the firmware of your Felix Pro L/XL please follow the steps below. Connect to your printer with the web interface. Firmware update FELIX Pro L/XL Page...
Page 4
Navigate to the firmware upload button in the drop down menu. Firmware update FELIX Pro L/XL Page...
Page 5
Make sure it’s set to Arduino DUE programming port. Firmware update FELIX Pro L/XL Page...
Page 6
Select the .bin file for your printer so if you have a XL the Pro XL.bin and for the L the Pro L.bin. Firmware update FELIX Pro L/XL Page...
Page 7
The machine will now begin it’s update routine this will take a couple of minutes the controller will disconnect during the process and will reconnect when it is done. When this is done we need to clear the old settings, see instructions below. Navigate to the console tab.
Page 8
Send the gcode M502 this will reset the internal memory of the machine. Firmware update FELIX Pro L/XL Page...
Page 9
Send the gcode M500 this will save the reset. After this we will need to calibrate the machine again, we will start with the bed leveling. Firmware update FELIX Pro L/XL Page...
Page 10
Calibration. For early versions go to the advanced tab > console and type in G32 S2 and press enter, immediately after that G33 to activate the bed leveling completely this will map the whole bed not just the 3 points or follow the steps below. Firmware update FELIX Pro L/XL Page...
Page 11
The machine will now measure 3 points on the bed, after that we need to map the bed itself for any bumps still present. We do this with G33. Firmware update FELIX Pro L/XL Page...
Page 12
Bed leveling: This tilts the bed in the software so the distance between nozzle and bed is the same everywhere. When to do this?: 1. After unboxing/moving printer. 2. When you see first layer printed lines are deviating from width across the print surface. Firmware update FELIX Pro L/XL Page...
Page 14
We already leveled the bed in the previous step so you don’t need to do this, we do need to calibrate the Z and the XY. XY and Z Nozzle calibration: These calibrations align the printheads with respect to each other to get an optimal dual head print. When to do this? 1.
Page 15
Review our products Help us to improve our products and services. It only takes a few minutes! www.felixprinters.com/survey (a small reward is waiting for you) Manuals & tutorials FELIX Community www.felixprinters.com/support www.felixprinters.com/community V2 - 2019 Quick Start Manual FELIX Pro L/XL www.felixprinters.com/support Zeemanlaan 15 support@felixprinters.com...